(1) After switches were soldered, please be careful not to clean switches with solvent

开关浸焊后,注意不要用溶剂清洗.

(2) In the case of using soldering iron, soldering conditions shall be 280ºC max and 3 sec. max

在使用铬铁的情况下,焊锡温度应在280ºC 以下、3 秒以内.

(3) Right after switches were soldered; please be careful not to load on the knobs of switches.

浸焊后,注意不要在顶部施加负荷.

Design instructions(设计中应注意的事项)

(1) Follow recommended P. W. B. piercing plan in outside drawing page.

印刷基板的安装孔尺寸参见产品图.

3.3 Note(注意点)

(1) Please be cautious not to give excessive static load or shock to switches.

注意不要施加超负荷的压力或晃动插座.

(2) Please be careful not to pile up P. W. B. after switches were soldered.

开关焊接以后,印刷基板注意不要叠放.

(3) Preservation under high temperature and high humidity or corrosive gas should be avoided

especially. When you need to preserve for a long period, do not open the carton.

保管时尤其应注意避开高湿高温和有腐蚀性气体的环境.如需长时间保存,请不要打开包装箱.

(4) Panasert RH and RH6 shall be used as the standard insert machine (use N type clinch).

使用标准插入机器PANASERT 和RH6（使用N 式钉）

(5) Preservation under high temperature and high humidity or corrosive gas should be avoided especially, when

you need to preserve for a long period, do not open the carton.

特别注意避免将产品保存在高温、强温度或有腐蚀性气体的地方。若长期保存，请勿打开包装箱。